But what about the programming Code and the harrdware configuration?
I'm using Et200s whit Analog output
1CPU314C whit Cp343-1 lean
And i have problem whit the hardware configuration of CP343-1(6GK7343-1C10-0XE0) lean whit Et200s(6ES7151-3AA23-0AB0).
In fact, the Danfoss drives must drive borehole pumps (Forage 2, Forage 3, Forage 4)
In each borehole((Forage ) is installed an Et200s which will be linked to the s7-300(CPU 314C -2DP + cp343-1 lean) by fiber optics via the scalance x101-1.
I'm having trouble setting up the hardware configuration and network communication.
There is a dipswitch by the analog inputs, where you can choose if you want to control by Current (4-20mA) or Voltage (0-10V). In parameter 3-15,3-16 and 3-17 you can set the refrence source 1,2 and 3. The default is Refrence Source 1 Analog Input 53, and Refrence source 2,3 no function.
Is this what you were looking for? If not, let me know!
Is ok for the wiring.
But what about the programming Code and the harrdware configuration?
I'm using Et200s whit Analog output
1CPU314C whit Cp343-1 lean
And i have problem whit the hardware configuration of CP343-1(6GK7343-1C10-0XE0) lean whit Et200s(6ES7151-3AA23-0AB0).
In fact, the Danfoss drives must drive borehole pumps (Forage 2, Forage 3, Forage 4)
In each borehole((Forage ) is installed an Et200s which will be linked to the s7-300(CPU 314C -2DP + cp343-1 lean) by fiber optics via the scalance x101-1.
I'm having trouble setting up the hardware configuration and network communication.
Thanks
The driver is tuning whit both 4-20mA And 0-10V whit potentiometer.
Yes is FC202
Hello
Do you have any more info the drive you are looking to control?
Most likely it's a parameter change, but i cant help you out without any more info