Hello, is the Factory IO program still in development, and may we write contributions or would that be too complex? I have FactoryIO with only the MHJ Driver. That means i would be able to connect to a Software Siemens PLC? IS there not a hack available to use the MHJ driver as a gateway and send the communcation to a Software Siemens PLC?

To work with factory sim properly i have to ping it right ?

Because i´m not even able to ping plcsim i tried also 314C

I use standart plcsim inside mz step7, do i need plcsimadvanced installed to work it fine

Im not able to connect it with plcsim , 315 cpu pn,DP in hw , plcsim works fine but simulator says it cannot connect to plc and it writes also it have wrong parameters

Cool!

The tool is still in development and I will check out to make the communication to PLCSim better! Thanks for the feedback and have fun playing with the tool!

Yes, it works with real PLC, great!

Thanks a lot!

Should work fine with PLCSIM... Maybe it is a NetToPLCSim issue, I will try to avoid the tool in the future, but it will be a lot of effort.

Let me know if it worked with real PLC

OK.

Good luck. :)

outputs ok.

I think it PLSIM issure, becouse in nettoplsim all reads and writes propetly.

Later i will try on real PLC. Thanks

When write the outputs %Q, does the conveyor move forward or backward?

Thank for quick answer, but no, i dont have io modules in configuration, only stand alone PLC..

Do you have input module in hardware configuration?

If you have, then PLC will read input addresses on this module and rewrite. You have to change addresses on the module, or delete the module.